Comments on: TSD Airsoft/Paintball Full-Face Mask, Goggle Lens

By: Nancy J Baraff

Nancy J Baraff — Fri, 28 May 2010 01:24:46 +0000

The mask is well made except for the rubber face liner, not adhered well so each time you put the mask on of off so does the seal,
Rating: 2 / 5

By: Anonymous

Anonymous — Fri, 28 May 2010 00:39:19 +0000

This mask is decent for its price. The thing is, it tends to fall apart at the wrong moment, see, it’s held together by these little pointy things that snap into holes on the other side of the mask and if you pull to hard (i.e. when you’re putting it on) it will fall apart. Also, the padding falls of but it is actually more comfortable without the padding, just be sure to remove the glue.
Rating: 3 / 5

By: J. Cervantes

J. Cervantes — Thu, 27 May 2010 22:28:59 +0000

Flimsy, bendable, I have to admit I’m surprised it’s out on the market as face protection but also, I shot the lens directly with one of my rifles and it took a few shot before even getting a scratch…but use it as a backup nothing more.
Rating: 3 / 5

By: Conner Biggs

Conner Biggs — Thu, 27 May 2010 22:11:46 +0000

This mask is not really well made. The padding around the lens started coming loose after only a couple of uses. I give it a 3-star because of the exceptional peripheral vision. I can see 180 degrees to my left and right which is very helpful in an airsoft war.
Rating: 3 / 5

By: Jake Everett

Jake Everett — Thu, 27 May 2010 19:20:24 +0000

This is not even worth the money. This mask is very low quality. The plastic is very flimsy and bendable. The mask literally falls apart right away. The first time I wore it, the padding fell out. The lens is not solidly attached to the rest of the mask, and is very blurry to see out of. The mask was also bent when I opened it. I have used this mask for one airsoft battle, and I will never wear it again. I would not trust this thing for my life. It does not offer good protection.
Rating: 2 / 5